Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Trimming sideart  (Read 1194 times)

0 Members and 1 Guest are viewing this topic.

Minwah

  • Trade Count: (+3)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 7662
  • Last login:January 18, 2019, 05:03:20 am
    • MAMEWAH
Trimming sideart
« on: January 09, 2008, 07:38:50 am »
I am going to apply some sideart to cover the entire sides of my cabinet...the artwork is printed bigger than the required size to allow for error.

I was planning on trimming the art once applied using a sharp craft knife which I think will work for the most part but there are a few 'inner radiused' corners (not sure if that is correct terminology!) which I will not be able to use a knife for.  Any tips?
Logged
Pages: [1]
  
Go Up
« previous next »