Centering the hole for joystick mount

[childeb1]

How do you center the joystick shaft? Do you drill the hole first then route out the recess or vice versa? This is for a bottom mount joystick.

Do you eyeball it or is there a more exact method?

Thanks

CoreyH

[acevedor2]

Easiest way to do it in my opinion is to remove the shaft (usually just a clip holding it on) and then mark the mounting holes.  Draw a line from the lower left hole to the upper right hole and then a line from the lower right to the upper left hole.  Where they cross at the "x" is the center.  Then use a 1 1/8 i believe it is to cut the center hole out.  Good luck!

[javeryh]

I just layout the joystick mounting plate on the CP and drill out the center using a 1-1/8" bit.  I haven't come across a joystick that didn't center the stick in the mounting plate.

[miles2912]

Drill the hole and then center the stick, mark the mounting holes and then drill them.  After you confirm the joystick is perfect, route the underside to desired height.