Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Width Coil Problem  (Read 1018 times)

0 Members and 1 Guest are viewing this topic.

Solvalou

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 28
  • Last login:September 06, 2007, 01:25:08 pm
Width Coil Problem
« on: July 10, 2007, 09:38:51 am »
Hi!

I got a Electrohome G07 19".
If I twist the screw of my with coil nothing on screen changes. Should it regulate the size or what?
The PCB sends a comp Sync Signal, but my screen supports only VSync and HSync, or Negative V- and HSync.
So I decidet to put a Bridge on the connector between V- and Hsync, the picture is perfect!
But the size and the position isnt correct. Can I do it a other way?

Thanks for your help!

cw

  • Trade Count: (+7)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 793
  • Last login:May 03, 2025, 09:26:58 pm
  • Game over man game over
    • The Cab
Re: Width Coil Problem
« Reply #1 on: July 10, 2007, 03:30:36 pm »
the width coil on a g07 does very little as far adjusting the size I have found.  A 1/2" at most
will be gained or lost with it.  You can however get Bob Roberts horizontal width kits ....
http://therealbobroberts.net/width.html

all the info is in the link...

hope this helps