Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: wg4600 no control over brightness....  (Read 1478 times)

0 Members and 1 Guest are viewing this topic.

cw

  • Trade Count: (+7)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 793
  • Last login:May 03, 2025, 09:26:58 pm
  • Game over man game over
    • The Cab
wg4600 no control over brightness....
« on: May 17, 2007, 02:51:53 pm »
subject line says it all...
 

 
 pulled and check the pot on the neck pcb
 checked r 419 and r 418




Logged

Ken Layton

  • Guru
  • Trade Count: (+1)
  • Full Member
  • ****
  • Offline Offline
  • Posts: 7061
  • Last login:October 12, 2021, 12:25:59 am
  • Technician
Re: wg4600 no control over brightness....
« Reply #1 on: May 18, 2007, 12:22:30 am »
The SCREEN pot on the neckboard rarely goes bad. It's the pot on the video interface board ("Black Level Control") that goes bad all the time.
Logged

cw

  • Trade Count: (+7)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 793
  • Last login:May 03, 2025, 09:26:58 pm
  • Game over man game over
    • The Cab
Re: wg4600 no control over brightness....
« Reply #2 on: May 18, 2007, 03:18:21 pm »
pot was replaced with the cap kit...
Logged

Ken Layton

  • Guru
  • Trade Count: (+1)
  • Full Member
  • ****
  • Offline Offline
  • Posts: 7061
  • Last login:October 12, 2021, 12:25:59 am
  • Technician
Re: wg4600 no control over brightness....
« Reply #3 on: May 18, 2007, 07:27:09 pm »
And you adjusted the black level control?

Did you resolder all the bad solder joints on the monitor main board and the daughter boards?

Did you swap the video interface board with one from another 4600 series monitor to isolate the problem to that board?
Logged

cw

  • Trade Count: (+7)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 793
  • Last login:May 03, 2025, 09:26:58 pm
  • Game over man game over
    • The Cab
Re: wg4600 no control over brightness....
« Reply #4 on: May 18, 2007, 09:25:34 pm »
yes


yes


yes


thanks for the help ken.... this one is driving me nuts
Logged
Pages: [1]
  
Go Up
« previous next »