Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: G-force 2 with D9200?  (Read 1712 times)

0 Members and 1 Guest are viewing this topic.

skirge66

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 181
  • Last login:June 03, 2003, 06:25:58 am
  • the stupid will normally punish themselves
G-force 2 with D9200?
« on: April 08, 2003, 03:39:08 pm »
I have a 32mb G-force2 video board sitting around, I would like to use this card with my newly purchaced D9200 monitor. will this card do well with the monitor. I'm wanting to say it's an ATI but I'm not certain.

Logged
skirge66

Diplomacy is the art of saying "nice doggy" until you find a bigger rock to throw

shmokes

  • Just think of all the suffering in this world that could have been avoided had I just been a little better informed. :)
  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 10397
  • Last login:September 24, 2016, 06:50:42 pm
  • Don't tread on me.
    • Jake Moses
Re:G-force 2 with D9200?
« Reply #1 on: April 08, 2003, 06:14:57 pm »
It's an Nvidia not ATI.  I mean, it could be any of a number of manufacturers, but Nvidia makes GeForce graphic chipsets that compete with ATI's Radeon chipsets.  It should work fine with your monitor, though.
Logged
Check out my website for in-depth reviews of children's books, games, and educational apps for the iPad:

Best Kid iPad Apps

seaner

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 124
  • Last login:October 21, 2003, 02:10:16 pm
    • http://www.beerbot.ca/mame
Re:G-force 2 with D9200?
« Reply #2 on: April 10, 2003, 01:15:25 am »
FYI, I just tried my gf2 with my D9200.
It works, sure.. but when I wan the config tools, I couldn't get a LOT of modes to show up.. got the "OUT OF RANGE" message on the screen.
This happened mainly with the lower frequency modes, 15khz, 16khz, 25khz.  It would be possible to configure up the GF2 to work fine if you only want to run the vga frequencies..
this was using svgaline.. your mileage may vary of course.
Logged
Pages: [1]
  
Go Up
« previous next »