Main > Main Forum

How do I make square holes for bolts in metal control panel?

<< < (2/4) > >>

ahofle:

--- Quote from: leapinlew on March 02, 2007, 06:23:17 pm ---I recommend Kens method.

I do not recommend Fozzys method.

--- End quote ---

 :laugh2: :laugh2:

FrizzleFried:
Both Ken and Fozzy are NUTS!  Much much too hard to use either of their method!  I have found the best way to do what you are asking is to simply drill a hole and use a square file to file it out.   Cleanest way to do it by far!   ;D

rlemmon:
Your all nuts ! He needs to go to lowes and get a square drill bit. ;D

johnm160:
A square router bit is much faster and cleaner.  ;D

FrizzleFried:
Blow torch?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version