Main > Main Forum

How do I make square holes for bolts in metal control panel?

(1/4) > >>

rackoon:
Like the title says I need to make square holes in my metal CP so my bolts holding my joystick wont spin when I tighten them. I was hoping to use black bolts with no screw driver notch on them. Should I try a file or may by a carbid blade in my jig saw.

So how is every one else solving this? :dizzy:

Fozzy The Bear:

--- Quote from: rackoon on March 02, 2007, 04:43:35 pm ---Like the title says I need to make square holes in my metal CP so my bolts holding my joystick wont spin when I tighten them. I was hoping to use black bolts with no screw driver notch on them. Should I try a file or may by a carbid blade in my jig saw.

So how is every one else solving this? :dizzy:

--- End quote ---

Drill a hole then file it out square with a square needle file..... It's really quick and easy to do. Try it.

Best Regards,
Julian (Fozzy The Bear)

Ken Layton:
Drill a hole and file it out. That's how I have always done it.

leapinlew:
I recommend Kens method.

I do not recommend Fozzys method.

 ;)

Fozzy The Bear:

--- Quote from: leapinlew on March 02, 2007, 06:23:17 pm ---I recommend Kens method.

I do not recommend Fozzys method.

 ;)

--- End quote ---

:dizzy::laugh2: :laugh2:
ROFL What is this Lew.... "National Confuse a Newbee Day" LOL  ;D

Best Regards,
Julian (Fozzy The Bear)

Navigation

[0] Message Index

[#] Next page

Go to full version