Main > Main Forum
How do I make square holes for bolts in metal control panel?
Fozzy The Bear:
OK OK I take back my first answer......
The best way to cut these holes is with a "thermal lance" This is a high pressure gas plasma cutter cooled by liquid nitrogen on the end of a 12 foot pole designed for cutting through up to 4" plate steel.... Favoured by large scale safe crackers. Works like a dream. Even cuts great trackball holes. ;)
Anyway!!! Who says the hole wants to be square... It's Like So Uncool to be square Dady'o...
Best Regards,
Julian (Fozzy The Bear)
johnm160:
Can I get a cheap one at Harbor Freight?
rackoon:
I had a feeling you guys were going to say that. :banghead:
So off to Home Depot it is, to buy a square drill bit :angry:
johnm160:
Good Choice ;D
shardian:
Just use your teeth like normal people. Don't listen to these yahoos.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version