Author Topic: scan line compression question (Read 1239 times)

MATTWOOKIE · « **on:** November 11, 2006, 08:02:54 pm »

I recently swapped a bad chassis for another chassis that was old but previously working and I now have a two inch line were the scan lines seem to be compressed. I have tried adjusting all the basic controls and nothing made a difference. Does anyone know what causes this and can it be fixed with a re-cap of the chassis? The attached picture shows the problem well if you look at Spiderman's foot. Thanks.

D_Zoot · « **Reply #1 on:** November 12, 2006, 10:20:46 am »

You appear to have a linearity issue. I would definitely cap that monitor.

Regards,
D

MATTWOOKIE · « **Reply #2 on:** November 12, 2006, 11:01:51 am »

Thanks for the info. I will get to re-capping soon.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: scan line compression question (Read 1239 times)

MATTWOOKIE

scan line compression question

D_Zoot

Re: scan line compression question

MATTWOOKIE

Re: scan line compression question