Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: idiot in need of help  (Read 1083 times)

0 Members and 1 Guest are viewing this topic.

myntik1

  • Trade Count: (+6)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 416
  • Last login:April 26, 2021, 12:03:28 pm
  • I'm part Jerry Lee and part Jerry Lee Lewis
idiot in need of help
« on: October 31, 2006, 09:08:52 pm »
Recently I overcame my fear of monitors and jumped in with both feet.  I just did a cap kit and replaced the flyback on a G07.  Now my monitor looks like this.  I'm a monitor newb - is this caused by bad soldering or did I not hook something up right.  Ken, Saint, Peale - someone HELP!
Logged
full-time sucker for part-time pay

Ken Layton

  • Guru
  • Trade Count: (+1)
  • Full Member
  • ****
  • Offline Offline
  • Posts: 7061
  • Last login:October 12, 2021, 12:25:59 am
  • Technician
Re: idiot in need of help
« Reply #1 on: November 01, 2006, 01:23:30 am »
You have no vertical deflection. Bob Roberts explains in his G07 monitor page.

You might have a crack/break in the leads of the two vertical output transistors or there's a "fuse resistor" in the vertical circuit that fails (usually it's very delicate & breaks easily) if you bump it while doing the capkit (in the vicinity of capacitor C412).
Logged
Pages: [1]
  
Go Up
« previous next »