Billabs BL27CB0P factory menu?

[conkerkrusher]

Does anyone know how to get into this, the rgb settings are waaaaaay to high when running the PS2 on it.

[Atomiswave]

Perhaps some potentiometers to the RGB wires could do the job

[StephenH]

Perhaps the PS2 is outputing a 5V signal when your monitor is wanting a 1V signal? 

[mairsil]

Personally, I would like to fix some nasty bowing in one of my corners. I can live with it right now, but I would rather fix it.

[Atomiswave]

Ask Wei Ya if they could apply a fix for these annoying bowings. I would. Billabs doesn

[conkerkrusher]

Perhaps the PS2 is outputing a 5V signal when your monitor is wanting a 1V signal? 

I think this is the case, though i have no idea how to fix this issue.
BTW if anyone else want to hook up thier ps2 to this monitor here are the hookups for the ultimarc adapter.
the connection in red is how to do it. Though the issue now is that it is putting out too much signal.
anyone want to educate me on how i could fix this?

Billabs guys arnt that bad, here is the info they sent me that at least got me a picture


CGA is tricky in that it could be separate sync instead of composite sync.

Does your system have a R,G, B, Gnd, H-sync, V-sync?

If so, we'll do the following: first let's define the wires from your system.

Use Gnd, H-sync, V-sync for signal output wires from your system, and

gnd, h-sync, v-sync for monitor input wires.  The RGB wires stay with rgb monitor wires.

You need to try any of the combinations below:

Gnd to gnd, V-sync to v-sync (leave h-sync unhooked).

Gnd to gnd, H-sync to v-sync (leave h-sync unhooked)

Gnd to gnd, V-sync+H-sync to v-sync (leave h-sync unhooked)

Gnd to v-sync+h-sync, H-sync+V-sync to gnd.

so on and so forth...


Chances are your system has separate video outputs and they are of reverse polarity.

You have basically 3 wires from your system (unknown) that need to connect properly

to the 3 wires from the monitor.  There are 3! combinations here.

 

Be sure to turn off the monitor each time you try something.  The picture should either

show up, or turn it off, and try another combination.

 

Be safe!

 

Ben

Billabs Tech Support

--------------------------------------------------------
BILLABS Manufacturing
Manufacturer of Amusement Products and Gaming Devices
Industrial monitors, power supplies, commercial speakers
--------------------------------------------------------

[mamerocks87]

there has been bowing problems on these billabs multisyncs?