Author Topic: How do I wire a Miniature Momentary Contact Pushbutton? (Read 1781 times)

javeryh · « **on:** February 03, 2006, 04:08:06 pm »

I have a bunch of "A" buttons from Happs for admin functions. http://www.happcontrols.com/pushbuttons/49057700.htm

THANKS!

unclet · « **Reply #1 on:** February 03, 2006, 04:29:00 pm »

one pin is wired to ground, the other pin is wired to your encoder.

I do not think it matters which pin you connect ground to ... just pick one.

javeryh · « **Reply #2 on:** February 03, 2006, 04:59:36 pm »

That's it? Sounds easy enough to me. THANKS!

unclet · « **Reply #3 on:** February 03, 2006, 05:01:36 pm »

I got a couple of those buttons from Radio Shack and that is how I wored them up .... they work fine.

SirPoonga · « **Reply #4 on:** February 03, 2006, 05:05:53 pm »

That's it? Sounds easy enough to me. THANKS!

Yep, a switch is just like touching two wires together, doesn't matter which pin does what, as long as it completes the circuit.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news