Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: Quick question...  (Read 1287 times)

0 Members and 1 Guest are viewing this topic.

BenDalton

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 33
  • Last login:May 29, 2012, 09:28:07 am
  • KingsQuest was the sh*t. I miss old-school Sierra
Quick question...
« on: September 28, 2005, 10:14:27 am »
So, I just acquired a bad SF2 conversion cab which I'm going to make into my MAME cabinet. Since I've never done this, I just have a couple quick questions about artwork.

1) What materials should I request for my marquee and for my cp-overlay (which will reside under plexi/lexan)

2) How much should I expect to pay to get those two pieces printed up?? (online vs. locally)


Thanks again for the input!

mahuti

  • Wiki Master
  • Trade Count: (0)
  • Full Member
  • *****
  • Offline Offline
  • Posts: 2757
  • Last login:September 18, 2024, 01:16:22 pm
  • I dare anything! I am Skeletor!
Re: Quick question...
« Reply #1 on: September 28, 2005, 10:46:48 am »
Marquee and CPO, approximately 30-40$ each. I would recommend going online through mamemarquees.com. Great service, great quality, and they know how to make the stuff we want, rather than some local guy that has no clue.

Raspberry Pi, AttractMode, and Skeletor enthusiast.