WinIPAC

[Willypill]

I set up all my controls in WinIPAC and when I click on 'Program', it starts to program and when it gets to player 3 & 4, my computer makes a beep and it just stops there.  It won't go any futher than player 3 & 4.  I have a 4 player control panel.  What would be the problem?

[sc1103]

Did you configure WinIpac so that it knows you have a IPAC-4 and that the connection is correct (PS/2 vs. USB)?

[Willypill]

Yes I did this.

[Willypill]

Why would the IPAC 4 not be responding to players 3 & 4?  I have it wired up exactly the same as players 1 & 2.

On the IPAC 4, only one light is on when I power it up.  It's the player 1 & 2 light.  The other light never comes on.  This is frustrating.

[Hoopz]

Have you emailed Andy at Ultimarc?  I would do that.  And check out their forums.  Someone may have had the same problem posted there.

[Hoopz]

And you made sure you are connecting the wires to the proper blade on the microswitches?  Make sure that no part of a wire is touching another wire/blade. 

Also, double check your grounds from players 3/4.  If you daisey chained them, you should be ok, but it never hurts to double/triple check everything.