Need monitor help....

[Ovalblue]

I just posted a topic on the software forum last night regarding my arcadeVGA card driver installation.  Well it looks like it finally got the driver signed. 

My last problem which I still have no clue how to fix is my monitor alligning the picture.  The arcade monitor is a standard CGA 27" monitor, the picture below is the best config I could get the picture at thats at 640x480. 

Anyone know what the problem is?  Do I need to install something else?  Is the monitor junk?  I really dont want to spend $500+ on a new D9200 monitor if i could getthis one working.

You guys have been great so far... hopefully you can help me past my LAST hurdle... I really wanna get it working!  =(

-Aki

[Pee-Wee]

Funny that ... ... looks abit like my problem on my EGA monitor,

Check out my post  AGP > TO EGA > RGB:S

As for the allinment, have you tryed 1024x768 on 60hz? sounds crazy, but it works! also you need to get an application to mess around with the position of the screen!

[dabone]

What does the display look like in bios?


(This monitor/card combo should work even before the windows drivers are loaded)
(I.e. you  should get a stable screen in your bios before windows loads.)


If you are not getting a stable pic, then it's most likely a hardware issue (Bad cable, monitor might need seperate syncs instead of composite syncs, etc.)


Later,
dabone