Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Using High Voltage probe  (Read 1189 times)

0 Members and 1 Guest are viewing this topic.

menace

  • Trade Count: (+5)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 2565
  • Last login:November 08, 2024, 01:49:35 pm
Using High Voltage probe
« on: March 30, 2005, 07:52:33 am »
Just got my B&K Hv-32 probe off ebay (not bad for 6$) and was wondering if there were any cautions or tips from the pros here on its useage.  My understanding is that the lead clips to the monitor frame and the needle slides under the anode cup and voila--reading time--correct?
Logged
its better to not post and be thought a fool, then to whip out your keyboard and remove all doubt...

Ken Layton

  • Guru
  • Trade Count: (+1)
  • Full Member
  • ****
  • Offline Offline
  • Posts: 7061
  • Last login:October 12, 2021, 12:25:59 am
  • Technician
Re: Using High Voltage probe
« Reply #1 on: March 30, 2005, 09:52:41 am »
Yes, that is correct. Make sure the alligator clip is securely connected to the monitor metal frame or ground strap.
Logged
Pages: [1]
  
Go Up
« previous next »