Help with Arcade monitor

[hbelanger]

Hi all,

I'm new to the list and already I really need your your help.

I have a PC configured with mamewah that I want to connect to an old 19" arcade monitor.
The monitor was pulled out of a working cabinet and should be good.
I've downloaded the 15khz boot disk from omnicade and connected my homemade cable
but all I get is a yellow screen with refresh lines

I built a vga cable and used the following pinout

Pins
1- Red
2- Green
3- Blue
5- Gnd
13- -Hsync
14- -Vsync

Is my monitor bad ? if so I can I test it ?? or do I need a video amplifier

Thanks in advance

Hugues

[SirPeale]

Isn't this you?

MameWorld.Info Forum Link

[hbelanger]

Yes

[hbelanger]

I was told on a different board that I need a video amp does anyone in here know of any homemade video amp circuitry ?

Thanks
Hugues Belanger

[SirPeale]

Yeah, I was the one that told you about Ultimarc's video amp.

Since you're looking for homebrew, see this site:

http://www.mameworld.net/pc2jamma/

[menace]

does anyone read the FAQ anymore???