Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Hey Dabone!  (Read 908 times)

0 Members and 1 Guest are viewing this topic.

Justen

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 23
  • Last login:February 14, 2007, 10:10:46 pm
  • I want to build my own arcade controls!
Hey Dabone!
« on: January 25, 2005, 10:37:25 pm »
Dabone,
    A while ago you said we had the same 27" monitor, which a sharp image si-327 manual works for. I am trying to connect the monitor through a JPAC and using an arcade vga card, but am having alot of trouble getting the sync right, the picture will not hold vertically and scrolls real slowly despite my best efforts.
I know this prob been covered a few times but do you have an idea how to sort the sync on this particular monitor?
Much appreciated
Logged

dabone

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 898
  • Last login:July 15, 2025, 08:32:17 pm
  • Time to work...
Re: Hey Dabone!
« Reply #1 on: January 26, 2005, 10:03:52 am »
If I remember correctly, that chassis has a switch to go from positive/negative sync.

Found it, it's the switch closest to the rear of the board near the video connector.

Make sure those switches are set to negative.
(Towards the outside of the board.)


Later,
dabone
Logged
Pages: [1]
  
Go Up
« previous next »