Author Topic: k7000 P538 w/ vert. foldover (Read 1084 times)

silverballer · « **on:** September 30, 2004, 11:29:00 am »

Hey guys n gals,

We have a WG K7000 that has a vertical foldover issue at the BOTTOM of the screen. We've already recapped the entire board, verified all resistors in circuit are well within tolerances and also changed the vert. output (never suspected this, but we had one so we did it anyway). All to no avail. $:-\$
If anyone has any input on this issue it would be greatly appreciated.

Thanks in advance.

Ken Layton · « **Reply #1 on:** September 30, 2004, 11:50:39 am »

Have you adjusted the 50/60 Hz trimpot? That's what it does is adjust foldover.

If that doesn't help then replace the tantalum cap C51 (.68 uf @ 35 volt, value is CRITICAL) directly behind the 50/60 pot. If that still doesn't help then IC1 (UPC1397) should be changed.

silverballer · « **Reply #2 on:** September 30, 2004, 12:04:18 pm »

Thanks Ken, the trim pot was it. You just saved some grey hairs.

We ran into this problem a couple years ago but couldn't for the life of us remember the fix.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: k7000 P538 w/ vert. foldover (Read 1084 times)

silverballer

k7000 P538 w/ vert. foldover

Ken Layton

Re:k7000 P538 w/ vert. foldover

silverballer

Re:k7000 P538 w/ vert. foldover