WG-D9200 Connection Question....

[squizz]

 Okey i have the Wg-D9200 installed and are just installing the arcadeVGA card into the PC and was wondering about one question...

  I have a Jpac installed and noticed the plug goes from the Jpac to the pc , now on the WG-D9200 monitor the Cables go to the CGA and EGA connector for the SF2 Gameboard i have installed....

 So do i leave the connector on the EGA, CGA connector or will i have to connet to the VGA slot for the pc For emulating mame with the 15/25/31hz mode's !  ?

  Can someoen with the same set up let me know please..

Thank you

[GMZombie]

so you have a dual setup a game and mame? if so this is how i had to do my setup. when running the pcb i had to have the vga cable plugged in but also the cga/ega plug in with the ovbious that the connector was setup on the cga/ega to play the pcb. when i wanted to play mame i would simply unhook the cga/ega connector from the monitor and change it to the vga mode. for some reason my video would jump playing the pcb if i didnt have the vga cable hooked up. dont knwo why. but it wouldnt work if i had both hooked up when i wanted to use mame....hope this helps