Warning sign on my display adapter after installing CRTEMUDRIVER

[Elaphe666]

Is it normal that my display adapter on the device manager shows a warning sign indicating some kind of problem?
Do I have to leave Windows as testsigning off or on? I had to run bcdedit.exe -set testsigning on after installing CRTEMUDRIVER because it was never on after running the install program, but that didnt't work either and then I found out that I had to disable a security setting in my bios, which finally made it.

[Zebidee]

You must restart after installing the driver to get test mode on.

There will be a message at bottom-right. Can't remove the message, but is possible to change it if it really bothers you.

[Elaphe666]

I know. What I was asking was if that testsigning mode (indicated by the message you mention) should be left permanently on after the drivers have been installed. I will try enabling it today and see if the warning on the device manager is gone. If I can't fix that, I will try uninstalling the drivers and installing them again. Before installing the CRTEMUDRIVER I had the official AMD driver for my 7750 installed and without any warning.

[haynor666]

If I remember correctly test mode must pernament. But there is a program that can remove test mode watermark.

[Zebidee]

I know. What I was asking was if that testsigning mode (indicated by the message you mention) should be left permanently on after the drivers have been installed.

Yes