Two vertical lines left of screen.

[robbbby]

Board is k7000, it was recently recapped and new fly back installed.

The machine sat for a couple years after rebuild so I don’t recall if those lines were there previously.
Could this be an adjustment or would it be something wrong on the board?
Thanks

[Malenko]

for starters, dial down the screen knob in the back

[robbbby]

for starters, dial down the screen knob in the back

Thanks for the suggestion. I gave it a try and it just seemed to darken the screen. Although slightly less pronounced, lines are still there.

[Malenko]

start with that , then go through all the other adjustments, you can likely get it down to barely noticeable.  If you cant, then re-check your caps; but based on that first picture the screen and brightness are waaaayyyyy tooo high