Getting Windows 10 to work on an 800x600 monitor

[mcsizzles]

Hi,

I have the Makvision SVGA 800x600 monitor. It worked fine when my rig had windows XP on it, but I installed windows 10, so I could use internet safely and play some modern titles, now I get a message that says OVER SPECIFICATIONS.

The only way I can get the monitor to work in windows 10 is if I boot up the computer on a regular pc monitor and then switch the vga cable over to the Makvision once it is all booted up. Is there a way I can get this thing to work with my Makvision without having to plug and unplug it? lI have an arcadevga I could use if that helps, but right now i'm using my old GTX 570 video card.

Thanks!

Angel

[buttersoft]

Hmmm, something like CRU can instruct the system to use specific modelines only. You can remove the modes you don't want. It might work, if there's a Win10 update? I say that, as my own efforts to have CRU produce 15kHz modes on Nvidia have failed abysmally. But 15kHz on Nvidia is a special case, and this isn't a 15kHz mode you're after.

[TGov]

Going to bump this.  I have had a terrible time with my 2929 SVGA and Windows 7.  I can get the desktop to come up fine and Hyperspin, but half of the games go to Out of Range..... Then I can't get it back to the desktop without saying out of range and....well it has been a nightmare.