Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

  

Author Topic: 34inch sharp ktm  (Read 1009 times)

0 Members and 1 Guest are viewing this topic.

goukisama

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 22
  • Last login:January 08, 2016, 05:14:45 am
34inch sharp ktm
« on: January 01, 2016, 02:09:02 pm »
I just got back my chassis from arcadecup. I went and put it back into my cab and it came on fine. As i was adjusting the picture, the screen had faded it out. I thought it was a something on the control board but it wasn't. I went to adjust the controls on the flyback and after a while it kicked on. For a bit then it faded out again. Now i wont come back in. So i am asking, is my tube dead?

Sent from my SM-G900P using Tapatalk


grantspain

  • I personally prefer "bog trotter"
  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 6177
  • Last login:July 16, 2025, 06:33:55 pm
Re: 34inch sharp ktm
« Reply #1 on: January 02, 2016, 05:00:31 am »
unlikely there is a chassis fault,possible it is a dying tube-more likely the neck card is not fully home