Hitachi GMK-25FS2 service literature ?

[qrz]

an Arcade Route op brought this in today- DOA

looking for a schematic as there are a pair of resistors in the SMPS burnt beyond recognition.

startup caps are bad as well. but, of course,  can identify those .

no joy with any search engine .   

anyone ??

TIA

[MonMotha]

These are found on Neo 29 cabinets.  Might get you some more info.

I have an operator's manual which includes some troubleshooting flowcharts and other info, but no schematic.  It's also in Japanese.

Would you like me to scan it in?

I can also get you pictures or measurements off known working units if necessary or if you have stuff burnt beyond recognition.

[qrz]

tnx
 but, doubt that the chart will be of any use .   even in Engrish
the startup caps were each several hundred ohms of ESR
the resistors in question are also in the primary side and part of a timing network.

should have posted ref#'s.

will try to so do in a couple of days

[MonMotha]

Crap, I just noticed you said 25FS2, not 29FS2.

I only have the 29".  I have a friend with the 25" version, though, so I can probably get info, but it may take a while as he's super remote and generally uncomfortable with working on monitors.

Of course, if it's similar to the 29", what I have may be useful enough.  Probably not the case for the timing section, though :\

[qrz]

the reference numbers to ID are
R905 and
R906

edit:

customer brought in a working unit.
of course, same resistors burnt. 
measured as
R905   4.7 ohm .5W
R906   15 ohm .5W

replaced both with a 1 Watt of same resistances, along with 
C902  4.7uF/160 V  replaced w/10uF/250V   105 degree
C906  2.2uF/160 V  replaced w/2.2uF/200V  105 degree

works fine now