Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Does the chassis matter?  (Read 1329 times)

0 Members and 1 Guest are viewing this topic.

Jetto Funk

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 117
  • Last login:April 09, 2013, 03:10:28 pm
  • Moo
Does the chassis matter?
« on: December 20, 2003, 02:19:44 pm »
I believe my Kortek chassis is fried, would it matter if I put a differnt chassis on my tube?
Logged

tom61

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 495
  • Last login:September 18, 2017, 12:46:56 am
Re:Does the chassis matter?
« Reply #1 on: December 20, 2003, 03:33:05 pm »
As long as the chassis is compatable with your tube, no problem. See the 8liner's chassis thread for more info.
Logged

Ken Layton

  • Guru
  • Trade Count: (+1)
  • Full Member
  • ****
  • Offline Offline
  • Posts: 7061
  • Last login:October 12, 2021, 12:25:59 am
  • Technician
Re:Does the chassis matter?
« Reply #2 on: December 21, 2003, 01:41:40 am »
If I remember correctly, the Kortek chassis uses a high impedance vertical yoke (30 to 60 ohms). Measure the resistance of the green and yellow yoke wires to be sure. I think you have the ten pin connector on the picture tube (29mm neck diameter).
Logged
Pages: [1]
  
Go Up
« previous next »