Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: 2/3 24.8" Tri-Mode Makvision VGA Input Not Synching  (Read 954 times)

0 Members and 1 Guest are viewing this topic.

MK3FAN

  • Trade Count: (+7)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 975
  • Last login:May 09, 2022, 07:07:29 pm
2/3 24.8" Tri-Mode Makvision VGA Input Not Synching
« on: June 24, 2014, 07:41:12 pm »
Hey everyone. I have 3 24.8" Tri-Mode Makvisions and only 1 of them has a functioning VGA input. The other two don't sync. It's not a problem of input signal or anything like that because I'm using the same setup to test all 3. One of them works and the other 2 don't. It's definitely a sync issue because I am getting the vertical split lines and multiple identical images on the screen. Anyone ever experience this issue with their Makvision or have any knowledge on what causes it, other than simply having a bad chassis? Thanks for your time - Mike.

Edit: yes, the "1K/75K switch is in the 75K position."
« Last Edit: June 24, 2014, 07:52:54 pm by MK3FAN »
Logged
Current collection - 28 cabs, 4 pins. (32 machines and not enough room)
Pages: [1]
  
Go Up
« previous next »