Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Makvision 25 video wiring question (Solved)  (Read 866 times)

0 Members and 1 Guest are viewing this topic.

eclipso

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 124
  • Last login:August 21, 2018, 08:51:25 am
Makvision 25 video wiring question (Solved)
« on: April 24, 2014, 08:56:07 pm »
Im swapping out a dead monitor and just want to ensure I wire it back up correctly, going from a 6 pin wiring it into the mak 10 pin connector. The attached illustration is what I am thinking. The little bubbles just show a unused port(s).


*so I ended up calling Happ and he confirmed it for me, I didn't have to use both grounds just one is fine.
« Last Edit: April 26, 2014, 08:27:12 am by eclipso »
Logged
Pages: [1]
  
Go Up
« previous next »