Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Zombie Raid Question  (Read 1269 times)

0 Members and 1 Guest are viewing this topic.

JZSlenker

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 35
  • Last login:April 20, 2014, 10:06:50 pm
Zombie Raid Question
« on: April 20, 2014, 10:05:43 pm »
I recently purchased two Aim Trak guns from Ultimarc and have them setup on a test system that will become a fourth arcade cabinet for my office.  This will be a light gun only cabinet.  I've been able to get every game setup and working superbly except Zombie Raid.
Please keep in mind that every other game (light gun and positional games alike) is setup and working properly.  I've done the in game light gun calibration multiple times and just can not get the calibration even close.  It is accurate at the dead center of the screen but as I move the crosshairs away from center, the game crosshair (visible when you enter your initials) moves away at a logarithmic rate.
Does anyone have an idea what the issue may be?  I have noticed there is no NVRAM file for it.  Is this normal?

« Last Edit: April 20, 2014, 10:07:46 pm by JZSlenker »
Logged
Pages: [1]
  
Go Up
« previous next »