Am I missing the video wires? Where does it go? Hanatrex Polo Question

[thehammer12]

Im a total Newbie and dont know jack about monitors especially the Hanatrex Polo 25" haha, I was wondering if Im missing the video wires? Also looking on the chassis....where does it go on there from the Jamma harness??  I see a few open connections but not sure what goes where.....


Although the pics make parts of the chassis board look burnt, its not....mostly dirty and dusty with bad lighting (sorry Im in the garage haha).

Am I missing anything that you all can tell?

[grantspain]

you are missing the remote board

[thehammer12]

you are missing the remote board

Is it possible to find those anywhere?

[grantspain]

http://www.ebay.co.uk/itm/HATAREX-POLO-REMOTE-PCB-WITH-LEAD-USED-WORKING-/160757063449?pt=UK_Video_Games_Coin_Operated_MJ&hash=item256dde1f19

if you got the monitor in a cab then the remote is normally on an extension cable and located in coin door area or behind monitor bezel

[thehammer12]

http://www.ebay.co.uk/itm/HATAREX-POLO-REMOTE-PCB-WITH-LEAD-USED-WORKING-/160757063449?pt=UK_Video_Games_Coin_Operated_MJ&hash=item256dde1f19

if you got the monitor in a cab then the remote is normally on an extension cable and located in coin door area or behind monitor bezel

SWEET, much appreciated. What about the video and power input? Does that video connector come from the jamma harness? And power input comes from ac....

[grantspain]

yeah the 6 pin header is direct from jamma connector-it should be marked on a sticker on the frame just below the connector what pin does what

the power in is mains(no isolation transformer required)-its a 3 pin mate n lok connector btw
http://www.mikesarcade.com/cgi-bin/store.pl?sku=MNL03P

[thehammer12]

Grantspain, I owe you big time 

I found the Remote pcb in a box, the monitor didnt come from a cabinet. I got it from another member as-is along with some spare parts, well It worked. I swear I almost tossed it last week because it was separated from the wire and thought it was a scrap part haha.




and I figured out the video and power input, it took a little tweaking but I also got everything powered up.....




ULTRAMAN..........

Now time to get joysticks and buttons and wire them up, and good tutorials or videos on that?