Author Topic: Upright Pac cabinet CP measurements? (Read 1786 times)

mushmouth · « **on:** November 18, 2003, 10:21:15 am »

If anyone has ready, easy access to an upright Pac cab, would you be so kind as to run your tape measure across the CP and take down the measurements? The Gods will reach down and smooch you on the mouth in appreciation.

mushmouth

General Zod · « **Reply #1 on:** November 18, 2003, 04:23:11 pm »

Greetings ,

These are the specs I came up with.

Hope this helps!

Michael

mushmouth · « **Reply #2 on:** November 19, 2003, 01:09:59 am »

Thanks General Zod. It's kind souls like you that make this board a beautiful place to frolic.

*grin*

paigeoliver · « **Reply #3 on:** November 19, 2003, 01:26:42 am »

Also, remember that the last 2" or so of the panel overlaps the glass, so you can't put any controls there.

mushmouth · « **Reply #4 on:** November 19, 2003, 05:09:27 pm »

So you can't mount a 2-1/4 trackball on it?

mushmouth · « **Reply #5 on:** November 20, 2003, 10:20:57 am »

--BUMP (It's an important question)

paigeoliver · « **Reply #6 on:** November 24, 2003, 03:56:50 am »

Quote from: mushmouth on November 20, 2003, 10:20:57 am

--BUMP (It's an important question)

Yes, you can get even a 3" trackball (with plate) on a Pac panel. My first cabinet ever was a Capcom bowling that was a Pac converstion, it had the 3" trackball with plate and it just BARELY fit.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news