Author Topic: Qix plastic overlay buttons question (Read 1861 times)

iscariot · « **on:** January 28, 2013, 12:10:06 pm »

Hey folks. I'm restoring a Qix control panel...I wanted to make a clear plastic overlay for it and so I did some basic measurements and it seems to fit fine except that one of the two buttons is a little sticky now. Is there an easy way to fix this?

Malenko · « **Reply #1 on:** February 04, 2013, 12:58:09 pm »

Quote from: iscariot on January 28, 2013, 12:10:06 pm

Hey folks. I'm restoring a Qix control panel...I wanted to make a clear plastic overlay for it and so I did some basic measurements and it seems to fit fine except that one of the two buttons is a little sticky now. Is there an easy way to fix this?

dish washer


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Qix plastic overlay buttons question (Read 1861 times)

iscariot

Qix plastic overlay buttons question

Malenko

Re: Qix plastic overlay buttons question