Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: arcade monitor wire harness help  (Read 1321 times)

0 Members and 1 Guest are viewing this topic.

KonkeyKong

  • Trade Count: (+5)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 228
  • Last login:October 10, 2021, 09:57:07 pm
  • Monkey is my business and business is good.
arcade monitor wire harness help
« on: October 27, 2012, 05:21:02 pm »
Hopefully pictures soon - camera charging.

My son and I were rotating the 29" monitor on a Nanco Exceleena Red candy cab when I heard him say "oops".  A cable got snagged and the pins got pulled out of a molex connector.  The intact connector that is attached to the monitor has 5 wires: yellow, black, green, gray white, in that order.  The gray and white wires run to one connection point on the monitor board, while the yellow, black, and green wires run to a second connection point further away on the board. 

The cable that got pulled comes from the cab and only has 4 wires: yellow, gray, white, purple, order unknown on the pulled end.

Everything was progressing quite smoothly until this literal snag.  Any assistance would be extremely appreciated.
« Last Edit: October 27, 2012, 05:59:41 pm by KonkeyKong »
Logged
Pages: [1]
  
Go Up
« previous next »