Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Nintendo VS with both center and off-set molding?  (Read 2067 times)

0 Members and 1 Guest are viewing this topic.

DLinkOZ

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 125
  • Last login:March 22, 2017, 08:12:46 am
    • The DaveCade
Nintendo VS with both center and off-set molding?
« on: October 15, 2012, 02:38:02 pm »
I picked up a nice VS cabinet, internal electronics gutted but externally complete (coin door, bezel and marquee plus hardware, control panel, etc).  I pulled the left side molding, saw it was offset and placed an order.  After pulling the right side, it's standard center-aligned t-molding.  Has anyone seen this?  It's one of the later cabinets, built with the panels within slots routed into the side pieces.
Logged
Pages: [1]
  
Go Up
« previous next »