60 in 1 jamma bar top build

[quintinbiker]

Hi there, this is my 2nd buld, well, I had this wood lying around, sorry, didn't take pics of the cuts i made.

But here it is...

[quintinbiker]

Gave it 2 coats of primer, had some rattle can spray paint in the garage, primed it gray.

[quintinbiker]

Here i gave it two coats of blue, well, blue was the only color i had, and thought of doing something else, then i decided to try the blue.

[quintinbiker]

Just for the record, this is the brand spray paint i use, Proudly South African.....

[quintinbiker]

Gave it a coat of crystal clear coat, have to run to hardware shop in the morning and get some more, and cut the rest of the pannels.

[quintinbiker]

I'll have to check that for you.

[quintinbiker]

I decided to make a change cause i wasn't happy with the color, so i decided that mat black might look better, and with a few coats of matt clear on the matt black the paint job will last longer. so, i went for matt black and yellow, looks awsome i think.

[DaOld Man]

Looking good!
Are you planning to not use T molding?

[quintinbiker]

I'm thinking of using t molding but i don't have a router though, if i can borrow a router from someone and get the right bit i will put t-molding on.