FREE MONITORS KORTEC AND NANAO-working!-GONE GONE GONE

[mrcram]

I have already replaced these monitors and do not want to store them any longer.  Please takes these off my hands.  I live in the Portland, Oregon metro area.  Call Ryan (503) 975-0746 if you can pick these up in my garage.  Need to take all of them.  There will be more arcade parts that I will be putting up here later.

26 inch Nanao ms8 monitor (switchable from 25khz to 15khz plug and play) out of a Daytona USA twin cab.  Colors are a little dull but I have not messed with pcb knobs to increase brightness, etc.  Slight screen burn.




27inc Kortec VGA monitor 2938F out of a PGA Golf Tour Cab.  Full picture but colors bad on one side.  I was told by TV repair guy that the tube needs to be replaced but chasis was good. (update-flyback and tube gone.  only the chasis board is left.)


I have another 26 inch Nanao ms8 monitor out of a Daytona USA twin cab.  Not working.  I searched all over chasis and talked to TV guy.  Fuses and everything else test out good on meter but found a burnt out resistor on the back.  Was told it was a simple soder and cheap fix.

[mrcram]

Sorry, the nanao monitors are 25" not 26.

Sent from my LS670 using Tapatalk

[mrcram]

Gone!

Sent from my LS670 using Tapatalk

[Gray_Area]

Please put that in the original post title.

[mrcram]

Please put that in the original post title.

How about I put my fist in your mouth.  Sorry to waste your precious seconds.

[Ginsu Victim]

Please put that in the original post title.

How about I put my fist in your mouth.  Sorry to waste your precious seconds.

That was a bit much.

[Gray_Area]

Please put that in the original post title.

How about I put my fist in your mouth.  Sorry to waste your precious seconds.

It's a simple forum decora - and maybe a requirement in posting/updating posts. But, see, I'd have to go look that up to be sure.