Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Nanao MS-2931 and pc vga connection.  (Read 1516 times)

0 Members and 1 Guest are viewing this topic.

jvlk

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 29
  • Last login:September 28, 2013, 08:44:24 am
Nanao MS-2931 and pc vga connection.
« on: January 15, 2012, 12:35:49 pm »
I had my monitor first hooked up through a j-pac, but Andy recommended I hooked up the monitor straight to my pc instead of the j-pac.
But before I do this do I have to switch anything on the monitor, or can I stick it right in the d-sub connection on the monitor?
The d-sub is right next to the current wires which goes to the jamma connector board, Do i have to unplug that or can I just leave it there?

Thx
Logged

grantspain

  • I personally prefer "bog trotter"
  • Trade Count: (+1)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 6177
  • Last login:July 25, 2025, 09:21:43 am
Re: Nanao MS-2931 and pc vga connection.
« Reply #1 on: January 15, 2012, 12:58:34 pm »
res not higher than 640x480
Logged
Pages: [1]
  
Go Up
« previous next »