Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Cut a small slit for the marquee with a router?  (Read 1635 times)

0 Members and 1 Guest are viewing this topic.

upper2bits

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 62
  • Last login:December 20, 2011, 05:52:45 pm
Cut a small slit for the marquee with a router?
« on: July 26, 2011, 11:30:04 am »
If I find a bit the same size as the depth of the marquee would it make sense to order the marquee 1/8 inch longer and cut notches in both sides to slide the marquee into?
Logged
Pages: [1]
  
Go Up
« previous next »