kill_one ,
how did you install it ..
I'm getting mad
shiryu55 first download EcoTUIODriver from github:
https://github.com/ecologylab/EcoTUIODriverExtract the zipped file into a folder.
Open the "EcoTUIODriver" directory and then open the "Driver" folder.
Open the "x64-Driver-Installers" folder.
First run the "Installvmulti1" file and then the "Installvmulti2" file.
Download the "Gunguncon2" software:
https://yadi.sk/d/YZBrP4zo3NeYFmconnect your guncon2 to an usb port (no driver found, question mark in the device manager)
open a cmd in administrator
go to x64/redist
launch "1-install driver.bat"
accept driver installation (driver are not signed)
you must see : install completed successfully
launch "2-install device.bat"
accept driver installation (driver are not signed)
you must see : install completed successfully
copy wdapi1200.dll (159ko) to your windows/system32 directory
copy wdapi1200_32.dll (148ko) to your windows/syswow64 directory and rename it to "wdapi1200.dll"
if you don't do that, you will have a 0xc000007b error
(note: to uninstall, launch "uninstall device-1.bat" and after, "uninstall driver-2.bat")
you can verify in the device manager that all is ok like the screenshot I made
launch the gungun.exe
using gungun.exe (very simple)
the fist time you launch the application, you must see
resolution x and resolution y filled with your screen resolution and xmin, xmax, ymin, ymax set to 0. If you have nothing, the driver isn't well installed
you need now to click on the calibration button
move your gun on each side of your crt to set the minimum and maximum values on x and y
then click START on your gun to terminate calibration mode