Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Hor. width coil connection on a WG 19K4601  (Read 946 times)

0 Members and 1 Guest are viewing this topic.

ckong

  • Trade Count: (+2)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 159
  • Last login:October 19, 2020, 06:48:09 pm
  • Retro Games forever!
Hor. width coil connection on a WG 19K4601
« on: September 19, 2014, 03:41:38 am »
In order to pull out the chassis for a capkit I desoldered the two wires that connects the hor. width coil to the 19K4601 chassis PCB. Unfortunately I forgot to make a note or photo to remember which wire was connected to which pin, so now I am stuck reassembling the monitor again. Does it matter which wire of the coil goes to which pin on the 19K4601 chassis? Do I need to attach it anyway to have a picture?

Logged
Pages: [1]
  
Go Up
« previous next »