Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: Cutting Midway Control Panel  (Read 1613 times)

0 Members and 1 Guest are viewing this topic.

makoReactor

  • Trade Count: (0)
  • Newbie
  • *
  • Offline Offline
  • Posts: 1
  • Last login:December 28, 2008, 12:26:28 am
Cutting Midway Control Panel
« on: December 28, 2008, 12:08:47 am »
I have a pacman control panel I need to drill some holes in. It's the top metal part. I was wondering how to cut/punch holes for more buttons?

I know this is the woodworking section but I couldn't find a metal section!
Logged

shredso

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 141
  • Last login:January 27, 2020, 09:23:27 pm
  • I'm a llama!
Re: Cutting Midway Control Panel
« Reply #1 on: December 28, 2008, 07:34:32 pm »
get a metal hole saw.  or, depending on the size of the hole a metal drill bit.  If the bit or the hole saw isn't rated for metal it will burn out quickly or not work at all.
Logged
Pages: [1]
  
Go Up
« previous next »