Main > Reviews
Ultimarc UltraStik 360 Joystick
Ginsu Victim:
I like mine low. I bottom mounted my balltop U360s and my Happ Comps without any routing.
cadmium:
--- Quote from: Ummon on October 01, 2008, 06:50:26 pm ---Those do look a little low for comfort, unless you hold it near the top. Probably fine if standing up.
--- End quote ---
They are a touch low, but honestly I've had no problems with them, height-wise.
paulscade:
My setup: U360, hard spring, no restrictors, top mounted, dust washer under CPO.
I like the stick (even if I did mount it sideways ::) ). I did have a slight problem with the dust washer that was easily corrected:
http://forum.arcadecontrols.com/index.php?topic=82241.msg891265#msg891265
Ummon:
I sit down at my machines so especially a bat type that is so low is hard to leverage accurately in-game.
TheShanMan:
I've noticed that one of my u360's has centering issues. I figured I could correct it with the windows calibration tool, but it still seemed to be an issue. I noticed that the little black plastic sensor thing that's directly below the magnet isn't on level. Could that be the cause of my problem? If so I guess I have a board that shouldn't have passed QC!
I also noticed, and I'm not sure if this is a potential problem or not, that with my restrictors on the magnet can come in contact with the base of the post, causing the magnet to lift slightly away from the stick. That happens only if I'm pulling slightly on the stick, but that kind of bothers me since I wonder if that will cause accuracy/calibration issues.
I'll probably run these issues past Andy privately, but thought I'd mention them here in case anyone else has noticed them.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version