Main > Reviews
Ultimarc UltraStik 360 Joystick
Ginsu Victim:
As far as the board, are your posts all screwed in properly? It sounds more like a post issue instead of the board.
The magnet issue is weird. I have only tried the circular restrictor and have never had this problem.
TheShanMan:
Yep. All screwed in properly/completely. I took it apart and put it back together again just to be sure. And you'd probably never know that the magnet was lifting unless you were watching it while trying to make it happen. I just happened to notice that it comes REALLY close to the base of the posts (like a hair width away!), so I tried to make it happen by pulling up on the stick and sure enough, it touched and lifted slightly.
Ginsu Victim:
--- Quote from: TheShanMan on October 07, 2008, 12:08:04 pm ---And you'd probably never know that the magnet was lifting unless you were watching it while trying to make it happen.
--- End quote ---
Oh, I have. I've tried it out in a lot of different ways. I've also tried pressing in directions really quick, just to see if the magnet would come off or shift, but that hasn't been an issue.
Is the PCB as far on the posts as they possibly can go? Pics would be nice, just so we can see what you mean. I see no reason why the PCB would be warped in any way, so I don't understand why it isn't sitting level.
TheShanMan:
It's on all the way. You misunderstood. My pcb isn't warped. It's that little round black plastic sensor thing that's in the center of the pcb - it doesn't sit flat on the pcb. One side of it is raised up so it's at a bit of an angle. My other u360 is fine though.
Ginsu Victim:
Ahhhhhhhh.....now I understand. Sounds like a problem that Andy would probably take care of.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version