Author Topic: Some noob question about arcade power and Q/D's (Read 1364 times)

knave · « **on:** September 10, 2007, 12:25:23 pm »

Is it safe to use quick disconects (fully insulated) for the 5 and 12v in an arcade cab?

My Power supply is making wierd noises and I want to replace it and the harness is hard wired into it.

I'm thinking of adding Q/D's to all the wires so I can swap out my PS now and at any time in the future. (I would Like to get the same Dynamo type that bolts up to the same holes.)

Will they get hot or anything?

What about using them for 110v (to the isolation Transformer?

If this is a really bad idea what should I do instead...?

SirPeale · « **Reply #1 on:** September 10, 2007, 02:45:50 pm »

They're fine. They're rated quite high.


Main	Restorations	Software	Audio/Jukebox/MP3	Everything Else	Buy/Sell/Trade
Project Announcements	Monitor/Video	GroovyMAME	Merit/JVL Touchscreen	Meet Up	Retail Vendors
Driving & Racing	Woodworking	Software Support Forums	Consoles	Project Arcade	Reviews
Automated Projects	Artwork	Frontend Support Forums	Pinball	Forum Discussion	Old Boards
Raspberry Pi & Dev Board	controls.dat	Linux	Miscellaneous Arcade	Wiki Discussion	Old Archives
Lightguns	Arcade1Up	Try the site in https mode		Site News


Unread posts \| New Replies \| Recent posts \| Rules \| Chatroom \| Wiki \| File Repository \| RSS \| Submit news

Author Topic: Some noob question about arcade power and Q/D's (Read 1364 times)

knave

Some noob question about arcade power and Q/D's

SirPeale

Re: Some noob question about arcade power and Q/D's