I want to say thank you for this excellent piece of software. I am having an issue, though, and was wondering if I could get a little bit of advice.
I am in the process of waiting for a defective ArcadeVGA card to be replaced from Ultimarc (Andy is really good about resolving problems when they happen, BTW!) So I'm not likely to use this utility permanently, but while I'm waiting for my card to make its way to England and back, I am trying to get Soft15KHz to work with my old nVidia Geforce2 MX card. I'm getting mixed results.
I installed ForceWare driver release 90 on my machine, set my resolution to 640x480, rebooted, and then installed the Soft15KHz "15kHz" mode. Rebooted again, plugged my hacked VGA cable into the arcade monitor, and Windows started up in 15kHz mode. However, the screen is automatically set to an emulated 1024x768 resolution, and extends my desktop all over the place. My mouse will not work properly, as it is configured for 1024x768, and the display is actually running a lower resolution and just extending the desktop offscreen. I can move the screen down a little bit, but cannot even make it to the taskbar, where I need to access Quickres.
I am almost 100% positive that nVidia's utility is the source of this problem, but am unsure of what I need to do. Should I try an older ForceWare driver?
If this turns out to be a really difficult issue, I can wait for my ArcadeVGA card to show up in a few weeks, but I miss my cocktail cabinet! Plus, Soft15kHz is a really cool piece of code!