Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: use router flush bit to flush cut the CPO?  (Read 1434 times)

0 Members and 1 Guest are viewing this topic.

bossyman15

  • Trade Count: (0)
  • Full Member
  • ***
  • Offline Offline
  • Posts: 416
  • Last login:March 05, 2012, 01:35:08 pm
  • I am now building my own arcade controls!
    • Bossyman15 Arcade Pics
use router flush bit to flush cut the CPO?
« on: April 28, 2006, 04:30:47 pm »
i checked wiki and artwork FAQs but i don't see anything about this.

i have CPO from mamemarquee.com and i don't want to remove the sticky side off the sticker sheet. so here's what i want to do.

put CPO on CP and put plastic sheet overlay on top of it and clamp it down and use flush bit to route flush the CPO to CP.

is that safe for CPO? will it tear it out or is it fine?
Logged
My website: www.bossyman15.com Lots of arcade pictures inside!
Pages: [1]
  
Go Up
« previous next »