I bought some laminate for my control panel. I haven't cemented it on yet and I'm looking for some advice.
I have a circular saw, and a utility knife. I will not be buying a router so which should I use? I am leaning towards the utility knife to score and then snap off the laminate.
When should I drill my holes in the panel, before or after I laminate it?
I was thinking I could drill the holes in the panel first, then laminate the top, then drill through the laminate using the existing holes. I'd put a scrap board under the laminate so I wouldn't chip it.
Or should I laminate it first and drill through the laminate side? I have no idea which method is appropriate.
Thanks for any help you can provide.