Greetings, All!
I previously posted that I had acquired an ATX power supply from PowMax which contained an auxilary power plug (similar to older AT style P.S.) enabling a single power switch solution, ie: power up PC and power strip powers up because is it powered by this aux port on p.s.
Unfortunately, I posted "success" message too hastily and wished to offer a correction so that others are not misled. The aux power port on this (and other) ATX power supplies that have them is powered on when you switch unit on in back....this is not what I was after.
I was under the mistaken impression upon first wireup that this unit was coming on when powerswitch was applied by motherboard.
Therefore, I went with the "CoBeav approach" and wired a relay directly into my powerstrip which causes the power strip to power up when receiving 12 volt signal when power is applied to the PC.
The writeup that he has provided provides a good summary of what I have done with the exception that I only needed to use a single pole for one side of the 110V connection.
Steve