UPDATE.
Still chipping away at the sideart stencil. Work has been busy. Came across a little problem during the transfer from DeltaCAD to Illustrator. I am about to post for answers.
Here's where it's at..... ALMOST DONE...... Just need to fix some path problems which is hindering the color fills.
The accuracy will still be in question due to the lack of quality scans/pics. Without 'Wade's helpful dimensions......wouldn't have started it!!
Looking good! I've been really busy lately too so I haven't taken as many measurements as I'd ideally like.
If there are any additional areas of the sideart which would benefit from more measurements, just highlight them on your image and post them here. Then I'll measure those areas.
Also, after your image is ready, I can print it on a large format printer and overlay it onto my cabinet, and provide you with adjustments where needed. We should be able to get it extremely accurate this way. Or, we could just go with it, if it is only off by fractions of an inch, I don't think anyone would ever know the difference unless they applied it right over top of the original.
There's no rush, but I'd really like to see this completed. This Taito project is on my backburner, compared to other projects, but I would like to help keep it moving when I can. Then hopefully, by the time I am ready to finish up this project, this artwork will be 100%.
Does anyone know approximately how much this would cost to get cut in one color of vinyl? At this point, that is what I'm leaning towards doing for my cab. I suppose, once the file is ready, I could take it to a sign shop and get prices for both vinyl and a paper mask (assuming they will cut a paper mask).
Keep up the good work!
Wade