Main Restorations Software Audio/Jukebox/MP3 Everything Else Buy/Sell/Trade
Project Announcements Monitor/Video GroovyMAME Merit/JVL Touchscreen Meet Up Retail Vendors
Driving & Racing Woodworking Software Support Forums Consoles Project Arcade Reviews
Automated Projects Artwork Frontend Support Forums Pinball Forum Discussion Old Boards
Raspberry Pi & Dev Board controls.dat Linux Miscellaneous Arcade Wiki Discussion Old Archives
Lightguns Arcade1Up Try the site in https mode Site News

Unread posts | New Replies | Recent posts | Rules | Chatroom | Wiki | File Repository | RSS | Submit news

« previous next »
Pages: [1]
  
Go Down

Author Topic: LEDBlinky error (SAPI Parameter)  (Read 252 times)

0 Members and 1 Guest are viewing this topic.

SBaron

  • Trade Count: (0)
  • Jr. Member
  • **
  • Offline Offline
  • Posts: 2
  • Last login:March 28, 2024, 09:35:41 pm
  • I want to build my own arcade controls!
LEDBlinky error (SAPI Parameter)
« on: February 27, 2024, 08:11:54 am »
Hi,

First post so plz be gentle as I did search but did not find anything and I would bet this has been covered somewhere at some point.  So, a link is also welcomed.

Trying to setup LEDBlinky under LanchBox.  Figured out I had to install LEDBlinky outside of the plugins folder (LaunchBox/LEDBlinky) or it would cause LB not to load with an error.  Now it loads.  When I exit LB the log file from LEDBlinky showed I needed to place the colors.ini and controls.ini files in the plugins folder (plugins/LEDBlinky).  So did that.  Now if I exit LB LEDBlinky shows that I have 1 last error:  Unable to set SAPI parameters. OLE error 80045039  Any ideas/suggestions?

TIA
Logged
Pages: [1]
  
Go Up
« previous next »